Amprobe TMA5 Mini-Vane-Anemometer - Manual (Page 13)

6
MAINTENACE AND REPAIR
If there appears to be a malfunction during the
operation of the meter, the following steps should be
performed in order to isolate the cause of the problem.
1. Check the battery. Replace the battery
immediately when the symbol “ ” appears on
the LCD.
2. Review the operating instructions for possible
mistakes in operating
Except for the replacement of the battery, repair of the
meter should be performed only by a factory Authorized
Service Center or by other qualified instrument service
personnel. The front panel and case can be cleaned with
a mild solution of detergent and water. Apply sparingly
with a soft cloth and allow to dry completely before
using. do not use aromatic hydrocarbons or chlorinated
solvents for cleaning.
The meter is accurate at low and mid-range air speeds.
Consistent use at very high speeds., ie, From the window
of a fast-moving car will damage the impeller’s bearing
and cause in-accuracy.
Battery Replacement
Replace your batteries when low battery icon appear on
LCD. To replace the battery:
1. Turn the battery compartment cover in a
COUNTERCLOCKWISE direction to remove it. (Fig.4)
2. Put the new battery between two contact pins and
battery anode side faces up.
3. Affix the battery compartment cover by turning it
in a CLOCKWISE direction.