Avago Technologies MegaRAID SAS 9266-4i User Manual
Page 13
LSI Corporation
- 13 -
MegaRAID SAS 9266-4i and SAS 9266-8i RAID Controllers Quick Installation Guide
July 2012
Attaching a CVFM02 Module Directly to the RAID Controller and Connecting to a CVPM02
Module on a Remote Mount Board
Installing the Clip Directly on the Remote Mount Board
Follow these steps to install the clip directly on the BBU-BRACKET-05 remote mount board.
1.
Place the remote mount board on a flat, clean, static-free surface.
2.
Ground yourself, and make sure that the system is grounded.
3.
Remove the clip and the remote mount board module from the package.
4.
Place the clip and the remote mount board module front-side-up on a flat, clean, static-free surface.
5.
Hold the clip to line up the screw holes on the clip with the screw holes on the remote mount board, as shown in
the following figure.
Figure 6 Installing the Clip Directly on the Remote Mount Board
6.
Secure the clip to the remote mount board in three screw holes with the screws and the nuts.
The screws thread through the front of the clip and the remote mount board.
Center the screwdriver carefully to avoid stripping the screw heads. Do not over-tighten the screws.
CV Clip
3_00895a-00