Avago Technologies Syncro CS 9286-8e - Manual (Page 32)

Avago Technologies
- 32 -
Syncro CS 9286-8e Solution User Guide
November 2014 Chapter 3: Creating the Cluster
Creating the Cluster in Red Hat Enterprise Linux (RHEL)
3.4.1.3 Configure SELinux
You need to configure SELinux policies to allow for clustering. Refer to Red Hat documentation to properly configure
your application.
3.4.2 Creating the Cluster
Configuring cluster software often occurs on a single node and is then pushed to the remaining nodes in the cluster.
Multiple methods exist to configure the cluster, such as using the command line, directly editing configuration files,
and using a GUI. The procedures in this document use the Conga GUI tool to configure the cluster. After the Cluster is
created, the following steps allow you to specify cluster resources, configure fencing, create a failover domain, and
add cluster service groups.
Perform the following steps to create the Cluster.
1. Launch the luci web interface by going to https://YOUR_LUCI_SERVER_HOSTNAME:8084 from your web browser.
The following window appears.
Figure 21 Create New Cluster Window
2. Log in as root for the user, and enter the associated root password for the host server node.
3. Go to the Manage Cluster tab.
4. Click Create.
5. Enter a name in the Cluster Name field.
NOTE The Cluster Name field identifies the cluster and will be referenced in
proceeding steps.
6. Add each server node in the Node Name field.
7. In the password field, enter the ricci password for each server node participating in the cluster.