6 exiting the scsi setup utility, 7 scsi pass-thru protocol, Exiting the scsi setup utility – Avago Technologies LSI SAS 3041E-R User Manual
Page 165: Scsi pass-thru protocol, Section 8.6, “exiting the scsi setup utility, Section 8.7, “scsi pass-thru protocol
Exiting the SCSI Setup Utility
8-27
Version 1.3
Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
8.6
Exiting the SCSI Setup Utility
Because some changes only take effect after the system reboots, it is
important to exit the setup utility properly. To exit, press Esc and respond
to the verification prompts. Some changes might be lost if you reboot
before properly exiting the setup utility.
8.7
SCSI Pass-Thru Protocol
The LSI EFI 1.1 Boot Services Driver Provides support for the EFI 1.1
SCSI pass-thru protocol. The LSI Driver implements this protocol
according to the EFI 1.1 specification. Refer to the appropriate EFI 1.1
documents for details and usage information. SCSI pass-thru protocol is
installed on SCSI Host Bus adapters only. It is not supported on fibre
channel controllers.