Avago Technologies LSI21040 - Manual (Page 19)

LSI21040 PCI to Dual Channel Ultra160 SCSI Host Adapter 2-1
3.75 pc 10.25 pc 11.25 pc 38.25 pc
4.333 pc
12 pc
12.938 pc
13.851 pc
48.583 pc
52.5 pc
34.5 pc
34.732 pc
Chapter 2
Installing the LSI21040
This chapter provides instructions on how to install the LSI21040 and
includes these topics:
•
Section 2.1, “Quick Installation Procedure,” page 2-1
•
Section 2.2, “Detailed Installation Procedure,” page 2-2
•
Section 2.3, “Completing the Installation,” page 2-25
•
Section 2.4, “Troubleshooting,” page 2-26
2.1 Quick Installation Procedure
This section provides an overview of the installation procedure. If you are
an experienced computer user with prior host adapter installation and
SCSI bus setup experience, this section may sufficiently describe the
procedure for you. If you prefer a more detailed guidance for installing
the LSI21040, proceed to
Section 2.2, “Detailed Installation Procedure.”
For safe and proper installation, check the user’s manual supplied with
your computer and perform the following steps.
Step 1. Ground yourself before removing this host adapter board.
Step 2. Remove the LSI21040 from the packing and check that it is not
damaged.
Figure 2.1 illustrates an example of this host adapter board.
Also refer to Figure 3.1 to see a more detailed drawing of this
board.
Step 3. Open your PC cabinet and select an appropriate open PCI slot.
Step 4. Insert the host adapter board.
Step 5. Connect the internal and external SCSI peripherals.