Extron Electronics RCP 2000 with ISS 506 - Manual (Page 10)

RCP 2000 with ISS 506 Support • Installation
Installation, cont’d
2-4 RCP 2000 with ISS 506 Support • Installation 2-5
Ethernet link
The RCP 2000 can also communicate
with the ISS 506 via an Ethernet link,
using the RJ-45 connectors on the RCP
and the ISS. The RJ-45 connector is
illustrated at right. The RCP 2000 can
be connected to the ISS either directly,
or indirectly through a LAN.
•
When connecting the RCP 2000
directly (no intermediate device
present, such as a network hub)
to the ISS 506, you must use a
crossover cable. See the table
below for RJ-45 crossover cable connections (T568A and
T568B are the wiring standards).
Pin Wire color
RJ-45 Ethernet Crossover Cable
Pin
1 White-orange
White-orange
Transmit +
Transmit + 3
2 Orange
Orange
Transmit –
Transmit – 6
3 White-green
White-green
Receive +
Receive + 1
6 Green
Green
Receive –
Receive –
N/A N/A 4 Blue Blue
5 White-blue White-blue
7 White-brown White-brown
8 Brown Brown
N/A N/A
N/A N/A
N/A N/A
Signal Signal
RCP 2000 end (T568B) ISS 506 end (T568A)
Wire color
2
4
5
7
8
1234567 8
Insert
twisted
pair wires.
Pins:
Side View
• When connecting the RCP 2000 indirectly (through an
intermediate device, such as a network hub) to the ISS 506,
you must use a patch (straight-through) cable. See the
table below for RJ-45 patch cable connections (T568B is the
wiring standard).
Pin Wire color Pin
1 White-orange White-orange Transmit + Receive + 1
2 Orange Orange Transmit – Receive – 2
3 White-green White-green Receive + Transmit + 3
4 Blue Blue N/A N/A
N/A N/A 5 White-blue White-blue
6 Green Green
7 White-brown White-brown
8 Brown Brown
Receive – Transmit –
N/A N/A
N/A N/A
Signal Signal
RCP 2000 end (T568B) Hub, etc., end (T568B)
Wire color
4
5
6
7
8
RJ-45 Ethernet Patch Cable