Extron electronic TP R BNC A - Manual (Page 12)

TP Receivers • Installation and Operation TP Receivers • Installation and Operation
Installation and Operation, cont’d
5 . For through-surface mounting (all except TP R 15HD A) ,
insert four #8 wood screws through the bracket and into
the four pilot holes. Tighten all four screws to secure the
receiver in place.
6 . For under-surface mounting , insert #8 wood screws into
the four pilot holes. Tighten each screw into the mounting
surface until just less than 1/4” of the screw protrudes.
7 . For under-surface mounting , align the mounting screws
with the slots in the brackets and place the receiver against
the surface, with the screws through the bracket slots.
8 . For under-surface mounting , slide the receiver slightly
forward or back, then tighten all four screws to secure the
switcher in place.
Projector mounting
All of the receiver models can be mounted on a projector
bracket using the appropriate optional mounting bracket,
Extron’s Mini Projector Mounting Kit (part #70-217-01)
(TP R 15 HD A) or Projector Mounting Kit (part #70-077-04)
(all other models).
Secure the mounting bracket to the receiver using two machine
screws in the side of the receiver (TP R 15HD A) or the three #8
machine screws provided (all other models). Secure the
receiver to a projector mount or other surface by inserting the
mounting bolt through the bracket’s slotted hole (figure 2-6).
A A -V
O
U TP
UT O U TP
U T
P O W
E R 1 5 V .5 A D C
L
R
B
A V IN P U T V ID E O
TP R AV
TP R 15HD A
Mounting
Bolt
C S YN C SO G C V IDE O N/C
L
R A U D IO
O U T P U T
A V IN P U T
R G B
P O W
E R 1 5 V .3 4 A M A X
Mounting
Bolt
Projector
Mounting
Bracket
Projector
Mounting
Bracket
Figure 2-6 — Projector bracket mounting a receiver
2-10
Rear panel features and cabling
TP R BNC A
TP R BNC AV
TP R AV
RGB INPUT
A-V INPUT
50/60 Hz
100-240V 0.3A
RGB OUTPUT
R
VIDEO
G B H/HV V
A
AUDIO AUDIO
L R
B SOG C SYNC L R
A
A-V AUDIO
L R
B L R
RGB INPUT RGB OUTPUT
R G B H/HV V
A
AUDIO
L R
B SOG C SYNC
POWER 15V .5A DC
L R
TP R 15HD A
A
A-V OUTPUT
L R
B
A-V INPUT VIDEO
AUDIO
POWER
15V .5A DC
L R
C SYNC SOG C VIDEO N/C L R
AUDIO
OUTPUT AV INPUT
RGB POWER
15V
.34A MAX
9 5
5 8
2 6 7 8 9
8 1 7
5
3
2 6 7 8 9
1 4 8 9
1 3 7
Figure 2-7 — Installation features, TP receivers
Transmitted signal cabling
CAUTION Do not connect this device to a computer data or
telecommunications network
RJ-45 termination must comply with the TIA/EIA
T 568A
wiring standards for all connections.
1 RGB video transmission connector — Attach one end of a TP
cable to this RJ-45 female connector (figure 2-7). Attach the
other end to an Extron TP 15HD or BNC transmitter. See
Termination of TP cable on page 2-15 for pin assignments.
2-11