PLANET ICS-2100 - Manual (Page 17)

User’s Manual of ICS-210x
-13-
2.2.3 Wall Mount Plate Mounting
To install the Industrial Equipment on the wall, please follows the instructions described below.
Step 1: Remove the DIN-Rail from the Industrial Equipment; loose the screws to remove the DIN-Rail.
Step 2: Place the wall mount plate on the rear panel of the Industrial Equipment. Figure 2-11 shows how to attach brackets to
one side of the Industrial Equipment.
Figure 2-11 Attach brackets to the Industrial Equipment.
Step 3: Use the screws to screw the wall mount plate on the Industrial Equipment.
Step 4: Use the hook holes at the corners of the wall mount plate to hang the Industrial Equipment on the wall.
Step 5: To remove the wall mount plate, reverse steps above.
2.2.4 Stand-alone Installation
To install an ICS-210x stand-alone, on a desktop or shelf, simply complete the following steps:
Step 1: Turn off the power of the device/station in a network to which the ICS-210x will be attached.
Step 2: Ensure that there is no activity in the network.
Step 3: Attach RJ-45 / SC Fiber cable from the ICS-210x to the network.
Step 4: Attach RS-232/RS-485 cable from the ICS-210x to the want to connect devices.
Step 5: Connect the DC power to the ICS-210x and verify that the Power LED lights up.
Step 6: Turn on the power of the device/station; the PWR LED (Green) should light when all cables are attached.