Equator EW510 - Manual (Page 11)

10 Washer Owner’s Manual
GROUNDING
This appliance must be grounded. In the event of malfunction or breakdown, grounding will
reduce the risk of electric shock by providing a path of least resistance for electric current.
This appliance is equipped with a power cord having an equipment-grounding conductor and
a grounding plug. The plug must be plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local codes and ordinances.
WARNINGS
- Improper connection of the equipment-grounding conductor can result in a risk of electric
shock. Check with a qualified or service representative or personnel if you are in doubt
as to whether the appliance is properly grounded.
- Do not modify the plug provided with the appliance: if it will not fit the outlet, have a
proper outlet installed by a qualified electrician.
CONNECTING TO THE WATER FAUCET
Please read the following steps carefully (Fig.3, Fig.4)
1. Connect the gray end of the hot-water hose to the hot-water faucet (Fig.3).
2. Connect the gray end of the cold-water hose to the cold-water faucet (Fig.3).
3. Connect two pressure -reducing valves [2] to each inlet valve [1] (see Fig.4).
4. Connect the white L-shaped end of hot-water hose to the pressure-reducing valve
connected to the inlet valve marked “H” (Fig.4).
5. Connect the white L-shaped end of cold-water hose to the pressure-reducing valve
connected to the inlet valve marked “C” (Fig.4).
CONNECTING THE DRAIN HOSE
Connect the drain hose to a drain duct (with internal diameter of at least 1.6 inches) or place
it for drainage in to a sink or a tub, ensuring that there are no kinks or bends. The free end
must be at a height of 31.5 inches from the floor, the hose must be fixed in the appropriate
hook on the upper part of the back panel (Fig.4)
(Fig.3) (Fig.4)