PLANET ICA-HM317 - Manual (Page 54)

53
Port Setting ‐ Baud Rate: Select data baud rate of RS-485 interface that
pan-tilt camera cradle will accept. When the length of
RS-485 connection is very long (longer than 200M), it’s not
recommended to use high speed connection (greater than
2400bps).
‐ Data Bits: Select data bits of RS-485 connection.
‐ Parity: Select parity bit “odd, even, or space”.
‐ Stop Bit: Select stop bit “1 or 2”.
Use Pelco-D Select this option and RS-485 interface will output pan-tile control
signal in Pelco-D format. This format is widely accepted by most of
pan-tilt pan-tilt camera cradles.
You have also input pan-tilt camera cradle’s address code in
‘Address’ field. This code must be identical to pan-tilt camera
cradle’s address code.
Use Custom
Protocol
When the pan-tilt camera cradle does not support Pelco-D protocol,
you can define a protocol’s detail by this function.
Please refer to pan-tilt camera cradle’s user manual to define
the protocol.
‐ Home/Up/Down/Left/Right: Input the command string
used to move pan-tilt camera cradle to home or
up/down/left/right position. You can click ‘Test’ button to
send command string for testing.
‐ Command 1 ~ 5: You can define extra pan-tilt camera
cradle control strings here by giving it a name (Command
Name) and command string (Hexadecimal Message). You
can also click ‘Test’ button to send command string for
testing.
When you finish with above settings, click ‘Apply’ button to save changes.