PLANET KVM-1610 - Manual (Page 16)

16
Note
Please use the CapsLock to toggle the upper and lower cases.
SVS: It shows the Smart View Setting; use  to open and  to close. The SVS
is blank and not clickable if the KVM is connected in parallel. If this option is
set to open, then you can make the switch by operating the Hot Key Switch
or Mouse Clicking or selecting the option by Auto Scan. You also can use
mouse to click this field.
Selection BAR: It shows the selection bar (Green); you can use the  keys on
the board to move the selection bar, and the situated position
indicates the selected target for giving instructions. For example,
if the selection bar points at C#05 and you press Enter, then the
system will switch to that particular PC or press the “Space BAR”
to start editing the name. Press F4 to enable/disable the SVS
option.
4. Instruction Hint Field:
:
(Move) Use the  keys on the keyboard or the mouse to move
the selection bar
SPACE:
(Edit) The “Space BAR” on the keyboard is used to start editing
the name of the PC or KVM.
ESC:
(Exit) Use the “Esc” key on the keyboard to exit the current
option or exit OSD.
F4:
(Auto Scan)
Use the F4 key to run Auto Scan, and you can set the
residing time, channel display time and mode of the Auto
Scan from System Setting.
F9:
(System Setting)
Use the F9 key to enter into the System Setting Menu.
F5:
(Clear Name
List)
Use the F5 key to clear the values of all Name fields. If
you clear the name list under the Master screen, then you
will also clear the name lists under all slaves. If you clear
the name list under a certain slave, then you only clear
the name list under that particular Slave KVM.
F1:
(Smart View)
It switches the Smart View Setting.