PLANET NAS-7200 - Manual (Page 10)

10
3.2 NAS-7200 - 2-Bay SATA NAS RAID Server
The NAS-7200 supports two 3.5-inch Serial-ATA (SATA) hard drives. NAS-7200
does not support low profile or half high hard drive.
HDD Install
1. Make sure the NAS-7200 is powered off
2. Open rear cover of NAS-7200
3. Make sure your hard drive is SATA interface and make sure you back up all pre-
existing data before use it on NAS-7200
4. To install Disk 1 that located on left side (rear view), make sure HDD top face to
left and connector side in front then slide the HDD into slot