PLANET PL-702 - Manual

PL-702 PL-702
Quick Guide Quick Guide
2011-AE0340-000
PLANET Technology Corporation
Tel: 886-2-2219-9518 Fax: 886-2-2219-9528
Email: [email protected] www.planet.com.tw
11F., No.96, Minquan Rd., Xindian Dist., New Taipei City 231, Taiwan (R.O.C.)
PLANET reserves the right to change specifications without prior notice. All brand names and trademarks are property of
their respective owners. Copyright © 2012 PLANET Technology Corp. All rights reserved.
Quick Installation Guide PL-702 (Twin pack x 2)
The installation procedure for the Powerline Configuration utility will vary depending on which operating system you are using on your computer.
The following procedure is for installation under Windows XP. Installation on other operation system is similar.
1. Insert the CD into the CD-ROM drive to initiate the Autorun program. Once completed, a menu screen will appear.
2. Click on the “Powerline Configuration Utility” hyperlink in PL-702 field to start the installation. If the menu screen is not shown, you can start
the installation as follows.

Click on Start Menu/Run.
 Enter “E:\Utility\setup.exe” in the appeared box, where “E” is the letter of your CD-ROM drive.
 Click on “OK” button.
3. The utility will be installed into your computer and a new icon called “Power Packet Utility” will appear on your desktop.
Further Configuration
If you want to configure more detail settings of
PL-702, please refer to user’s manual on the bundled CD.
If you have any difficulty on resolving the problem while installing or using the PL-702, please contact the dealer where you purchased this product
or you can contact PLANET directly at the following email address: [email protected]
Ethernet Cable (Twin pack x 2) CD-ROM
VERIFY THE CONTENTS INSIDE PACKAGE BOX
The package should contain the items plus PL-702/PL-702-KIT. If any item is missing or damaged, please contact the seller immediately.
NOTE : This utility is only for Windows 2000, 2003, XP, Vista and Windows 7.
Utility Installation for Windows
Internet
Cable/xDSL
Modem
PL-702-A
001101010
Power Line
PL-702-A PL-702-B
Laptop
PL-702-B
Step.1 Connect one Powerline Ethernet bridge to your
ADSL or Cable modem’s Ethernet port and plug it
into the nearest power socket.
Step. 2 Plug in the second Powerline Ethernet bridge in
your room or office.
Follow the steps below to install PL-702 in the house
Step. 3 Connect the PC via the network cable to the
Powerline Ethernet bridge.
Power Packet
Utility
LED Definition
LED Status Description
On Steady on indicate the Powerline device connect to the power outlet.
Power Off Power off
Green Device in standby mode
Ethernet
Off Ethernet Link not active
Green Steady on indicates the RJ-45 port has correctly connected to the network card of your PC or the Ethernet network
Off This HomePlug Ethernet Bridge is not connected
Data
Red Minimum connection indicates weak signal and slower network speed: less than 50Mbps
Orange Normal signal with standard network speed: 50-99Mbps
Green Excellent signal with optimal network speed: 100Mbps+
Button Definition
Button Description
Reset Hold the Reset button until the status lights begin to flash.
Security
Press security button during 1~3 seconds. Join a another HomePlug AV network
Press security button more than 10 seconds Set its security to random value