ProSoft Technology ILX69-PBS - Manual (Page 46)

Contents ILX69-PBS ♦ CompactLogix or MicroLogix Platform
User Manual PROFIBUS Slave Communication Module
Page 46 of 102 ProSoft Technology, Inc.
March 20, 2015
5.2.3 Configuration by Controller Application
The second option to configure the ILX69- PBS is through the controller application. If you’re
unable to install the AOP due to company policy or other reasons, you will need to manually
configure the module through the controller application.
The "Force User Config" parameter in this array must be set to 1. With this method, the
ILX69-PBS will not start any network communication unless the master and ILX69-PBS
configuration match. The following table outlines the mapping of the configuration data
image.
Word
Offset Configuration
word Data
type Low/High
Byte Description Valid values
0 Local:1:C.Data[0] INT
LOW Byte Reconfiguration Event 0
Reserved, set to 0
HIGH Byte Reconfiguration Event 1
1 Local:1:C.Data[1] INT
LOW Byte Reconfiguration Event 2
Reserved, set to 0
HIGH Byte Reconfiguration Event 3
2 Local:1:C.Data[2] INT
LOW Byte Bus Address 0 to 125
0 = ForceMasterConfig
1 = ForceUserConfig
HIGH Byte Force User Configuration
3 Local:1:C.Data[3] INT Reserved
4 Local:1:C.Data[4] INT Watchdog Time 0 to FFFFh
5 Local:1:C.Data[5] INT Number of valid config bytes
(starting with Local:1:C.Data[8]) 2 to 48
6 Local:1:C.Data[6] INT Reserved
7 Local:1:C.Data[7] INT Reserved
8 Local:1:C.Data[8] INT
LOW Byte Module 1 Type
HIGH Byte Module 1 Length
9 Local:1:C.Data[9] INT
LOW Byte Module 2 Type
HIGH Byte Module 2 Length
... ...
... ...
31 Local:1:C.Data[31] INT
LOW Byte Module 24 Type
HIGH Byte Module 24 Length
32 Local:1:C.Data[32] BOOL - IP Config flags 1, Static or
Dynamic 0 or 1
33 Local:1:C.Data[33] BOOL - IP Config flags 2, Static or
Dynamic 0 or 1
34 Local:1:C.Data[34] INT - IP Configuration 0 = BOOTP
1 = DHCP
2 = FIXED IP
35 Local:1:C.Data[35] SINT LOW Byte IP Address 00.00.00.00 through
FF.FF.FF.FF
…
…
HIGH Byte