ProSoft Technology PS69-DPS - Manual (Page 95)

PS69-DPS ♦ CompactLogix or MicroLogix Platform Reference
Profibus DP Slave Communication Module User Manual
ProSoft Technology, Inc. Page 95 of 108
May 9, 2014
Error Class Meaning Error Code
12 Resource 0 = Read Constrain Conflict
1 = Write Constrain Conflict
2 = Resource Busy
3 = Resource Unavailable
4 to 7 = Reserved
8 to 15 = User Specific
13 to15 User Specific
Error Code 2
Error code 2 is application specific.
Messaging Error Codes
The section includes all errors codes and conditions that can occur when using
the CIP messaging commands outlined in the previous sections.
 Your application should be constructed in a manner in which it catches the
two possible error cases listed below:
 CIP Message instruction failed itself
 The requested command returns an error in its request confirmation
Only if both possibilities are without any error has the requested command been
successful.
CIP Messaging General
Applicable are the generally known error codes for CIP Messages such as
"Service Not Supported". In this case, the parameters of the CIP Message must
be checked (Service Code, Class, Instance). All CIP error codes that are
returned by the module and their cause are described in the following table.
Note: Some CIP error codes are public and can be generated also by the Controller. Make sure
the error was not generated by the controller.
CIP Status Extended Status Meaning Cause Help
02 hex 00CA hex Resources unavailable
Out of segments System has no
segments left to execute
the command
02 hex 03E8 hex Resources unavailable
Out of CIP com buffer System has no CIP
communication buffer left
to execute the command
Check the number of
parallel CIP messages
send to the module. The
module can process 5
CIP messages in
parallel. Note that
RSLinx can already
consume 2 of this CIP
com buffers if the online
browser is active.
02 hex 0519 hex Resources unavailable
Out of command buffer System has no
command buffer left to
execute the command
Call support