Royal Sovereign RSL-380 - Manual (Page 6)

10
RSL-380
11
8. MAINTENANCE
4. Insert the film shaft into the roll of film
from the right side with the copper end last.
Align and insert the core adapter on the left
end of the film core
? ? ? ? ? ? ? ? ? ? ? ? @@ ? ?J@@L?hg? ?7@@1?hg? J@@@@Lhg? 7@@@@1hg? ?J@@@@@@L?hf? ?7@@@@@@1?hf? J@@@@@@@@Lhf? 7@@@@@@@@1hf? ?J@@@@@@@@@@L?he? ?7@@@@@@@@@@1?he? J@@@@@@@@@@@@Lhe? @@@@@@@@@@@@@@he? ? ? ? ? ? ? ? ? ? ?
LOADING LOWER ROLL FILM
1. Repeat steps 1-5 to load the lower roll film.
2. Once the upper and lower film is on the shaft, pull the film from the top and roll
down to the bottom roll to make certain that the film is aligned properly. Then
tighten the lower locking core screws.
NOTE: If the film is not aligned properly exposed adhesive will adhere to the rollers
and may cause the film to jam.
FILM THREADING
Refer to Figure 6
1. Do not apply any cleaning fluids to the rollers. Certain fluids may damage the
rollers.
2. Do not clean rollers with sharp or pointed objects.
3. Use adhesive remover to clean resin off of the rollers.
4. Use a damp cloth with water to clean the body of the machine.
5. Store machine in a dry clean area
5. Center the film on the shaft and lock it in
place with the locking core adapters
6.Carefully return the film shaft back into place.
Figure 1
Figure 2
Figure 3