Bose Solo 15 Series II - Manual (Page 6)

6 - English
Setting up the System Setting up the System
Placing the system
1. Move your TV so you can see the Audio Out panel.
2. Place the Solo 15/10 series II system where you had your TV.
Placementguidelines:
If placing the sound system in a cabinet or on a shelf, position the
front of the system as close as possible to the front edge of the
shelf for optimum audio performance.
CAUTIONS:
• If placing the sound system backed up to a wall, make sure there
is a space of at least 1" (2.5 cm) between the wall and the rear of
the system.
• With any placement of this product, make sure the ventilation
openings on the rear panel are not blocked.
Cable options
Connect your TV to the system using one of the three cable
options. The optical cable is the preferred method for connection.
Tip: If your TV does not have an optical, coaxial or analog
connector, see page 15.
1. On the back of your TV, locate the Audio OUT (digital)
connector panel.
Note: You must connect the audio cable through your Audio
OUT connector panel.
Option 1:
Optical (digital)
Preferred method
for connection.
Option 2:
Coaxial (digital)
Use if no optical
output is available.
Option 3:
Analog (stereo)
Use this connection if
no optical or coaxial
outputs are available.
Your TV's connector panel may not appear as shown.
Look for the shape (optical) or color of the connector.
2. Choose an audio cable.
Connecting your TV
Insert one end of the audio cable into the correct Audio OUT
(digital) connector on your TV.
CAUTION: If using an optical cable, remove the protective caps
from both ends. Inserting the plug in the wrong
orientation can damage the plug and/or the connector.