Ericsson W20 - Manual (Page 2)

Enabling UMTS/HSDPA Data
To access faster data speeds you will need to switch the unit from 2G to 3G mode. In 2G mode
GPRS/EDGE will appear in the configuration window, in 3G mode UMTS/HSDPA will appear.
Initial Setup:
Insert sim card: remove top lid on the W20 and insert sim above yellow sticker as shown
Antenna – Connect the supplied antenna
Power – connect power to the W20
Cable – connect the network cable to the W20 and your PC
Step 1)
Open HyperTerminal on your PC (Start – All Programs - Accessories – Communications -
HyperTerminal)
Step 2)
The new connection window pops up, enter W20 as the name and click ok
Step 3)
The connection window will pop up, choose your region and area code. From the ‘Connect Using’
option choose TCP/IP from the drop down box.
In ‘Host Address’ enter 192.168.1.1 and click ok.
Step 5)
In the HyperTerminal window – FWT login: root (press enter)
- Password: root (this will not appear as you type), (press enter)
Step 6)
‘Welcome to the Ericsson W2x FWT #’ will be displayed. Enter the following commands:
cf set cellular.2g.enabled false (Press Enter)
cf commit
(Press Enter)
# will appear on the next line.
Step 7)
Close HyperTerminal
The W20 is now in 3G mode, HSDPA or UMTS will appear in the configuration window.