Braun Silk-épil SuperSoft - Manual (Page 9)

9
• Before use, check whether your
voltage corresponds to the volt-
age printed on the transformer.
Always use the 12 V transformer,
type PI-41-77 D-1.
Description (see page 4)
Ö Soothing attachment
Ü
Tweezer grip selector
á Epilator head with
tweezer element
à Release bar for epilator head
â
Switch
ä Socket
ã
Cord connector
å 12 V transformer with plug
for power socket
Underarm and bikini line epilation
Use tests monitored by dermato-
logists have shown that the epilator
head may as well be used underarm
and at the bikini line. Be aware that
this area is particularly sensitive to
pain. However, the pain sensation
will diminish with repeated usage.
For this specific application, we
would like to give the following
advice:
• Before epilating, thoroughly
clean the respective area to
remove residue (like deodorant).
Then dry carefully with a towel
using a dabbing action to avoid
skin irritations.
• Hair should not be longer than
5 mm.
• After use, apply Silk·épil cream or
baby powder (don’t use alcoholic
deodorants).
How to operate your Silk·épil
Before starting off, make sure that
the epilator head is thoroughly
cleaned and disinfected. Your skin
must be dry and free from grease or
cream.
• Plug the cord connector into the
socket and plug the transformer
into an electrical outlet.
1
Select the tweezer grip:
+ full tweezer grip
for normal to thicker hair
– reduced tweezer grip
for finer hair
• Switching on
0 = Off
1 = For gentle epilation
2 = For normal epilation
3 = For high-speed epilation
2
Rub your skin to lift short hairs.
Apply the Silk·épil at right angles
(90°) against your skin. For best
epilation results, make sure that
the soothing attachment wheels
always
keep in contact with the
skin surface. Pressing gently,
guide it
slowly against the
direction of hair growth (see
illustration 2 ). Underarm, this
means guiding the appliance
in different directions. Do not
press too hard. On bony parts,
we recommend to use a lower
switch setting.
5303276_EE 1180_NA_P6-29 Seite 4 Freitag, 30. Januar 2004 1:56 13