Elation Professional Event MH - Manual (Page 25)

Event MH™
©Elation Professional® 25 Event MH™
proper and unique starting DMX address to each and every fixture. The DMX address is
non-destructive and will remain in the fixture’s memory even when the power to the unit is
switched off. Memory is backed-up and retain by an internal power source that should last
about five years. For proper DMX addressing see Section 10/Page 35 of this user manual.
- Slave setting
With this function, you can define the device as slave.
1. Select “SLAV” by pressing [UP] or [DOWN] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” if you wish to enable this function or press [DOWN] to select
“OFF” if you don’t.
4. Press [ENTER] to confirm or press [MODE/ESC] to return to main menu.
-DMX address setting via controller
With this function, you can adjust the desired DMX-address via an external controller.
This function can only be activated when the DMX-value of all other channels is set to "0" on
the controller. See “Remote DMX Addressing on page 35
- Program Run, Master setting
With the function "RUN", you can run the internal program. You can set the number of steps
under Step. You can edit the individual scenes under Edit. You can run the individual scenes
either automatically (AUTO), i.e. with the adjusted Step-Time or sound-controlled (SOUN).
The selection "ALON" means Stand Alone-mode and "MAST" that the device is defined as
master.