MIDEA Dryer MLE45N1BWW - Manual (Page 42)

DRYER CARE
WARNING
CONTROL PANEL
STAINLESS STEEL OR ANODIZED DRUM
DRYER EXTERIOR
DRYER EXHAUST SYSTEM
•
Certain internal parts are intentionally not grounded and may present
a risk of electric shock only during servicing. Service Personnel – Do
not contact the following parts while the appliance is energized: inlet
valve, control board and temperature-regulating thermistor (located
on blower housing).
CLEANING AND MAINTENANCE
•
Clean with a soft, damp cloth. Do not use abrasive substances.
•
Do not spray cleaners directly on the panel.
•
The control panel finish may be damaged by some laundry pre-
treatment soil and stain remover products. Apply such products away
from your dryer and wipe up any spills or overspray immediately.
•
To clean the stainless steel or anodized drum, use a damp cloth with
a mild, non-abrasive cleaner suitable for stainless steel and anodized
surfaces.
•
Remove the cleaner residue and dry with a clean cloth.
•
Clean with a soft, damp cloth. Do not use abrasive substances.
•
Protect the surface from sharp objects.
•
Do not place any heavy or sharp objects or a detergent box on the
dryer. Keep them on the purchased pedestal or in a separate storage
box. This may scratch or damage the top cover of the dryer.
•
Since the entire dryer has a high-gloss finish, the surface can be
scratched or damaged.
•
Avoid scratching or damaging the surface when using the dryer.
•
Should be inspected and cleaned yearly to maintain optimum
performance.
•
Disconnect the exhaust duct from the dryer and from the exhaust hood
(at the exhaust outlet) outside of the building.
•
Check the interior of the duct and remove any lint accumulation.
•
Be sure that lint is removed from the exhaust hood. Lint may collect in
the exhaust hood so that the flappers or louvers will not open or close
completely.
Dry
er
Saf
ety
Oper
ation
R
equir
ements
P
arts and
F
eatur
es
Ins
tallation Ins
tructions
Dry
er Use
A
p
p
e
n
d
ix
Dry
er Car
e
T
ro
u
b
le
sh
o
o
tin
g
42