Roland Blues Cube Hot 30W 1x12" Guitar Combo Amplifier (Vintage Blonde) - Manual (Page 7)

7
Panel Descriptions
10 PHONES jack
Connect headphones here. You can obtain powerful guitar sounds
just as if you were playing through the speaker. To adjust the
volume, use the [VOLUME] knob along with the [MASTER] knob.
* If a plug is inserted in this jack, no sound will be output from
the Blues Cube’s own speaker. This is convenient if you don’t
want loud sound to be produced from the speaker, such as
when you’re practicing at night.
11 LINE OUT jack
Connect this to your PA system or recorder. You can obtain powerful
guitar amp sound just as if you were playing through the speaker.
Recorder, etc.
You can use this in conjunction with an external PA system, or to
record your performance via direct line while monitoring the sound
from the Blues Cube’s speaker.
Adjust the output level using the [VOLUME] knob.
* To prevent malfunction and equipment failure, always turn
down the volume, and turn off all the units before making any
connections.
12 REC OUT O port
You can use a commercially available USB 2.0 cable to record the
sound of the Blues Cube into your computer.
You must install the USB driver when connecting the unit to
your computer.
Download the USB driver from the Roland website. For details, refer
to Readme.htm which is included in the download.
http://www.roland.com/support/
Turning the Power On/Off
* Once everything is properly connected (p. 6), be sure to
follow the procedure below to turn on their power. If you turn
on equipment in the wrong order, you risk causing malfunction
or equipment failure.
1.
Make sure that the Blues Cube’s [MASTER] knob and the
volume of the devices connected to the Blues Cube are set
to 0.
* Before connecting your instrument to the Blues Cube’s INPUT
jack, set the [MASTER] knob to the minimum setting (far left).
2.
Turn on the Blues Cube.
* Before turning the unit on/off, always be sure to
turn the volume down. Even with the volume
turned down, you might hear some sound when
switching the unit on/off. However, this is normal
and does not indicate a malfunction.
* This unit is equipped with a protection circuit. A
brief interval (a few seconds) after turning the
unit on is required before it will operate normally.
3.
Turn on the power of the devices connected to the LINE
OUT jack, PHONES jack, and REC OUT O port.
4.
Adjust the volume levels for the devices.
Before switching off the power, lower the volume on each of the
devices in your system and then TURN OFF the devices in the
reverse order to which they were switched on.
* If you need to turn off the power completely, first turn off the
unit, then unplug the power cord from the power outlet. Refer
to “To completely turn off power to the unit, pull out the plug
from the outlet” (p. 2).