Fcc compliance statement for american users – Epson Parallel Interface C82303* User Manual

Page 3

Advertising
background image

FCC COMPLIANCE STATEMENT

FOR AMERICAN USERS

This equipment has been tested and found to comply with the limits for a Class B digital device.
Pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful Interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However there is no guarantee that
interference

W

ill not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:

Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.
Consult the dealer or an experienced radio/TV technician for help

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1)

this device may not cause harmful interference. and

(2)

this device must accept any interference received,

including interference that may cause undesired operation.

FOR CANADIAN USERS

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus as set out in the radio interterence regulations of the Canadian Department of
Communications.

WARNING

The connection of a non-shielded printer interface cable to this printer will invalidate the FCC
Certification of this device and may cause interference levels which exceed the limits established
by the FCC for this equipment. If this equipment has more than one intertace connector. do not
leave cables connected to unused interfaces.

Seiko Epson Corporation shall not be liable against any damages or problems arising from the use
of any options or any consumable products other than those designated as Original Epson
Products or Epson Approved Products by Seiko Epson Corporation.

NOTICE

All rights reserved. Reproduction of any part of this manual, in any form whatsoever without Seiko
Epsons express written permission is forbidden.

The contents of this manual are subject to change without notice.

All efforts have been made to ensure the accuracy of this manual. However. should any errors be

detected, Seiko Epson would greatly appreciate being informed of them
The above notwithstanding, Seiko Epson can assume no responsibility for any errors in this

manual or their consequences.
Copyright © 1989 by Seiko Epson Corporation. Nagano. Japan

32KB Parallel Interface

32-KB-Schnittstellenkarte

Interface

32Ko

Interface en paralelo de 32KB

Interfaccia parallela da 32 KB

i

Advertising