Eurotech Appliances APOLLO 1U ICE FM12961 - Manual (Page 11)

APOLLO 1U ICE Fan control
Fan control
There are two fans on the APOLLO 1U ICE that can be controlled - the processor/CPU
fan, and the system fan. (The fan in the PSU runs at a predetermined speed.)
You can independently control the fan speed and preset using the BIOS screens. To do
this, follow these steps:
1
Press F2 during boot up and enter the BIOS setup facility.
2
Use the right arrow key to choose the Advanced menu.
3
Use the down arrow key to highlight Hardware Monitor, and then press Enter.
4
Ensure
Fan Speed Control
is highlighted, and then press Enter.
5
Highlight the fan you wish to set, and press Enter.
6
Change the fan speed to the desired percentage of its maximum capacity and
press Enter.
7
Exit from the BIOS screens, saving your changes.
© 2007 Eurotech Ltd Issue C 11