Epson C82069* - Manual (Page 12)

Installing the Card
Insert the card only when the printer is turned off.
Always insert it into slot A of your printer.
If the slot is horizontal, insert the card with the Epson logo on the
upper side of the card. If the slot is vertical, insert the card so the
Epson logo faces the A label. Follow the steps below to install the
card:
1. Turn off the printer.
2. Hold the card so that the arrow on the card is aligned with the
arrow on slot A.
3. Gently slide the card into the slot until it locks in place.
4. Turn on the printer.
Once you insert the PostScript CARD, you can select it using
SelecType.
Note:
l
Make sure your printer has at least 1.5 MB of memory,
including an optional expanded memory board or chips. You
will get an error message if you select the PostScript CARD
when not enough memory is installed.
l
Do not insert the card while the printer is turned on. If an
error occurs, refer to your printer manual for instructions.
1-2 Handing the PostScript CARD