Rear panel layout – Emotiva LPA-1 User Manual
Page 10
Page 10
Page 10
Rear Panel Layout
RCA Audio Inputs
These inputs provide the signal information
for each channel on the LPA-1. Simply
connect them to the appropriate output of the
preamplifier/processor or other preamp level
audio device. Channels 6 and 7 (far left) can
be used as a bridged output, in which case it
only requires an input from channel #6
Master Power Switch
This rocker switch provides the master power
for the LPA-1. After it is in the ON position, the
amplifier can be turned on manually from the
front panel switch or automatically with the
trigger input via 3.5mm input jack.
Channels 6 and 7 Bridged
Remote Turn On Jack
This 3.5mm jack accepts a 3-12 volt input for
remote activation of the LPA-1. This mates
directly with the Emotiva LMC-1 trigger output
and supplied cable. If building your own cable,
center is positive and outer shield is negative.
Speaker Outputs (5 way Binding Posts)
These are the speaker outputs. The 5 way
binding posts accept stripped speaker wire,
banana plugs (single or dual), or spade
connectors. Be sure to observe correct polarity
when connecting speakers and be sure that
the wires do not touch between positive and
negative terminals.
When bridging channels 6 and 7 to a passive
(non powered) subwoofer system, refer to the
diagram at left.
Power Receptacle
Standard IEC 3 prong power receptacle. It
is advised that this amplifier have a direct
connection to a wall outlet. Do not plug into a
“power strip”.