Everpure CGHE1 - Manual

CGHE1 Installation
& Operating Guide
Faucet Compatibility
Tools and Safety Equipment you may need (not provided)
Only “Open Vent” faucets function with a instant hot water dispenser tank.
Connecting a standard faucet will damage the tank and void the warranty.
2 mounting bracket screws
(and 2 plastic anchors if
attaching to drywall)
1 / 4 " (6.4 mm)
O.D. copper
tubing.
Materials required (not provided)
Components
tank mounting
bracket
tank
When you purchase the Everpure ® Commerical
Grade Instant Hot Water tank, contents include:
quick-connect
fitting
Shut-Off valve
with “T” fitting
(EV312120)
• ruler or measuring tape
• pliers
• hand or electric drill
• small drill bit for starter holes • 1 3 / 8 " drill bit - if no sink
hole exists
• safety glasses
• bucket or pan
• open-end wrench(es)
• gloves
• tubing cutter
EVERPURE INST
ANT HOT W
A
TER DISPENSER
(Connections must meet all local codes and ordinances.)
This hot water dispenser produces instant hot water of approximately 190°F (88°C) as dispensed
from the faucet.
This product is not intended to produce a continuous flow of hot water. The standard model will
produce up to 60 cups of water per hour at approximately 190°F (88°C). Due to high water
temperature, for safety reasons, the tank is not under pressure. Consequently, there is a slight
delay of water flow after the faucet has been activated. This is normal and indicates that the
expansion chamber is functioning properly.
IMPORTANT INFORMATION
560H486P01 REV E
quick-connect fitting
with filter and cap