Extron electronic SYSTEM 8/10 PLUS - Manual (Page 3)

Extron • System 8/10 P LUS • User’s Manual • P/N 68-412-01 Rev. A
Hughes Installation Configuration and Connections
Page 2 Page 2
System 8/10 Plus to Hughes-JVC DILA Projector Connections (RS-232)
Use the illustration below as a guide when connecting the System 8/10 Plus to
the Hughes-JVC DILA projector. Refer to projector documentation to continue
the installation.
________ When RS-232 control of the projector is used, the projector’s IR remote can be
used. However, because the projector’s IR remote does not communicate with
the System 8/10 Plus switcher, the projector and switcher can become out-of-
sync if the projector’s IR remote is used to change the projector’s input, picture
mute or power settings. Should this occur, press the power, mute or channel
buttons on the switcher to allow the projector and switcher to resynchronize.
________ If the installation includes looping (master/slave) switchers, see Chapter 5 of the
System 8/10 Plus User’s Manual.
________ If Video Loop Back is part of the installation, refer to pages 2-10 and 2-11.
COMPUTER
OUT
AUDIO OUT
P R /R-Y
P B /B-Y
REMOTE
AUDIO
AUDIO AUDIO
Y/C VIDEO
PC
R
R
L Y
G H/Cs
B V
RS - 232C
COMPUTER IN-2
CONTROL
COMPUTER IN-2 AV IN
RGBHV 5 BNC
9-Pin Female
CommAdapter
26-467-01
S-Video Adapter
15-Pin
Male
Composite
Video
S-Video