ELAN Home Systems THP650LS - Manual (Page 8)

THP525LS/THP650LS INSTALLATION MANUAL ELAN HOME SYSTEMS
Page 6 © ELAN Home Systems 2005 • All rights reserved.
Wiring (cont’d.)
When pre-wiring for a Home Theater, run 14-16AWG stranded speak-
er wire from the equipment location (head-end) to each speaker
location. Use speaker wall plates in the listening room as termination
points and use ELAN PSP6 or PSP12 Precision Panels for neat and
accurate speaker wire management at the head-end equipment
location.
Note: When pre-wiring for a Home Theater, it is essential to make
direct wire runs from the head-end to each speaker. Do not run
speaker wires in series or parallel, and do not “daisy-chain” speakers
to common wiring.
WARNING: Do Not Run Speaker
Wires Through Holes Shared
By High-Voltage Wiring!
Front
Rear
To
Home Theater
Receiver
SPK OUT
To
THP525LS/650LS/
650SS
SPK IN
Speaker
Wall Plates Front
Rear
Bannana
Plug
12-16 AWG
Stranded
Speaker Wire
Bannana
Plug
Bannana
Plug
Bannana
Plug
There are instances where TheaterPoint speakers will be connected
directly to an amplifi er. Use a high quality speaker cable of equal
lenghth for each Left and Right speaker directly from the amplifi er
to each speaker. The use of spade lugs or bannana plugs is recom-
mended.