Sennheiser Conversation ClearPlus True Wireless ANC Speech Enhancer - Manual (Page 17)

Using the earbuds
Conversation Clear Plus | 17
Pairing the earbuds with a Bluetooth
device
1. Take both earbuds out of the charging case (> 21). The distance
between the earbuds and the Bluetooth device should not exceed
40"/1 m.
2. Simultaneously touch and hold the right and the left multi-pur-
pose button for 4 seconds until you hear a melody.
The LEDs of the earbuds flash blue. The earbuds are in pairing
mode.
3. Activate Bluetooth on your Bluetooth device.
4. Via the menu of your Bluetooth device, start the search for new
Bluetooth devices.
All active Bluetooth devices in the proximity of your smartphone
are displayed.
From the list of found Bluetooth devices, select “ConCPlus1”. If
necessary, enter the default pin code “0000”.
If pairing was successful, you hear a melody and the LEDs of the
earbuds light up blue for 5 seconds.
Disconnecting the earbuds from a
Bluetooth device
▷
Via the menu of your Bluetooth device, disconnect the connection
to the earbuds.
The earbuds are disconnected from the Bluetooth device. The
earbuds then search for other paired devices.
If no connection is established within 3 minutes, pairing mode
is terminated and the earbuds switch to idle mode. If neces-
sary, repeat the steps described above.
If the earbuds are not connected to the Conversation Clear app
or are not paired with any Bluetooth device (the pairing list is
empty), pairing mode is permanently active.
max. 1 m/40 inch
ON
1
3 4
2
ConCPlus1
************
5 s
L R
4s
Hold