Dremel Digilab 3D45-EDU Printer for Education - Manual (Page 29)

Building
29
BEFORE yOU BUILD
1. Ensure an adequate amount of filament is
loaded (see page 23).
If 3D45 runs out of filament during a build,
it will pause until more filament is added.
2. Ensure glue is applied, build platform is
level and clear of objects.
3. Ensure the extruder and build platform
temperature is set according to the
filament type used, see page 25 for
details.
BUILDING FROM
ON-PRINTER STORAGE
1. On the main menu tap “Build”.
2. On the build menu tap the printer icon.
3. Tap the model file you would like to build.
(Use arrows to scroll through pages)
4. In the model detail page tap “Build” to
begin building process.
5. Your 3D45 will first align the extruder and
build platform to their zero positions then
the level sensor will lightly touch the build
platform to complete alignment. Your
extruder tip and build plate will begin to
heat which may take a few minutes. Once
the proper temperature is reached your
model will begin to build.
6. Once your object is finished your 3D45 will
automatically align the extruder and build
platform to their calibration positions and
cool the extruder tip and build platform.
7. Wait until the touch screen indicates that
the extruder and build platform is “cool” to
remove your object. See section
“Removing Object from Build Platform” for
object removal instructions.
DM 2610047405AB 03-18_3D45 3/27/18 9:51 AM Page 29