Ericsson LZT-1872R1A - Manual (Page 17)

17
OPERATION
GENERAL
Turning The Radio ON/OFF
The radio is powered ON by pressing and
holding the O button. All status indicators turn on
momentarily and after 2 seconds a short beep will be
heard and a message “---ON---” will be displayed on
the LCD. A self diagnostic test is performed when the
radio is first turned on if enabled through
programming. In the Interconnect Only Model, the
display will then display “CC SCAN“ if looking for the
contact channel or “READY“ when the control
channel has been found and a call request can be
placed. To turn the radio OFF press and hold the
O button again. After 2 seconds a short beep will
be heard and a message “TURN OFF” will be
displayed on the LCD. When turned off, the radio
retains the last user selections (unless programmed
for a particular power up option).
Additionally, the
O key is used to terminate
interconnect and individual calls.
Volume Adjust
The user can adjust the volume at any time
using the <and >buttons. If the volume is
adjusted while a call is in progress, no audible beeps
are heard. If no call is in progress, a short beep is
heard, in addition to the visual indication, if enabled.
Additionally, the user selected “off-hook” volume level
is saved separately from the user selected “on-hook”
volume level.
EDACS OPERATION
System Selection-Ramping Names
The operator can ramp through the
programmed system names list by pressing and
releasing the * key.