Equator Party Cooler none - Manual (Page 4)

4
1. Before using the appliance
Please read these instructions carefully. They will
give you important information on the
installation, operation and maintenance of the
appliance.
If you throw out an old appliance, it is important
to destroy the locking mechanism (not all
models).
Damaged appliances must not be connected to
the mains. All kinds of service and repair work
should be carried out by authorised electricians,
contact your dealer for further information.
The unit must only be used for the cooling of
beverages. Bottles may burst when being cooled
at very low temperatures.
Do not place inflammable liquids or gasses in
the appliance owing to risk of explosion.
It is best to place the appliance in a dry room
with good air circulation. Never use the
appliance outdoors. The room temperature
should be as low as possible (energy-saving),
but not lower than +5°C.
In placing the appliance, it must not be
exposed to direct sunlight or placed up
against a heat source.
The appliance must be placed on an even,
horizontal and stable surface. When moving
your appliance, do not seize hold of it under
the bottom, as there might be sharp edges.
2. Placing
5
3. Electrical connection
The appliance observes the following currect
EU directives:
Low Voltage 73/23 EG.
Electromagnetic Compatibility 89/336 EEC.
The appliance must be protected extra
according to the power regulations in order to
protect the user against dangerous electric
shocks in the case of defects.
If the socket is for a three-pin plug, a three-pin
plug is used and the wire with yellow/green
insulation must be connected to the earth
terminal (marked ).
If the socket is for a two-pin plug, a two-pin plug
is used. If you assemble this one yourself, the
wire with yellow/green insulation must be cut off
as close as possible to the place where it enters
the plug.
When changing the power cord, it must be
replaced by a power cord of corresponding
type.
In no circumstances cut in or remove parts from
the electric circuit.