Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 297)

set policy rule
D-Series CLI Reference 9-11
Defaults
None.
Mode
Switch command, read‐write.
Usage
Table 9‐35 provides the set policy rule data values that can be entered for a particular classification
type, and the mask bits that can be entered for each classifier associated with that parameter.
macsource Classifies based on MAC source address.
tcpdestport Classifies based on TCP destination port.
tcpsourceport Classifies based on TCP source port.
udpdestport Classifies based on UDP destination port.
udpsourceport Classifies based on UDP source port.
data Specifies the code for a predefined classifier. This value is dependent on
the classification type entered. Refer to
Table 9‐35 for valid values for each
classification type.
mask mask (Optional) Specifies the number of significant bits to match, dependent on
the data value entered. Refer to
Table 9‐35 for valid values for each
classification type and data value.
vlan vlan Classifies to a VLAN ID.
cos cos Specifies that this rule will classify to a Class‐of‐Service ID. Valid values
are 0 ‐ 4095. A value of ‐1 indicates that no CoS forwarding behavior
modification is desired. (Not supported on B3, C3, and G3.)
drop | forward Specifies that packets within this classification will be dropped or
forwarded.
Table 9-35 Valid Values for Policy Classification Rules
Classification Rule Parameter data value mask bits
ether Type field in Ethernet II packet:
1536 - 65535 or 0x600 - 0xFFFF 1- 16
ipproto Protocol field in IP packet:
0 - 255 or 0 - 0xFF 1- 8
Destination or Source IP Address:
ipdestsocket
ipsourcesocket IP Address in dotted decimal
format: 000.000.000.000 and
(Optional) post-fixed port: 0 -
65535 1 - 48
iptos Type of Service field in IP packet:
0 - 252 or 0 - 0xFC 1- 8
Destination or Source MAC:
macdest
macsource MAC Address: 00-00-00-00-00-
00 1 - 48
Destination or Source TCP port:
tcpdestport
tcpsourceport TCP Port Number:
0 - 65535 or 0 - 0xFFFF 1 - 16