Clear rmon capture, Clear rmon capture -22 – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 394
clear rmon capture
13-22 RMON Configuration
Defaults
If not specified, action defaults to lock.
If not specified, offset defaults to 0.
If not specified, asksize defaults to ‐1 (which will request as many octets as possible).
If slice is not specified, 1518 will be applied.
If loadsize is not specified, 100 will be applied.
If owner is not specified, it will be set to monitor.
Mode
Switch command, read‐write.
Example
This example shows how to create RMON capture entry 1 to “listen” on channel 628:
D2(rw)->set rmon capture 1 628
clear rmon capture
Use this command to clears an RMON capture entry.
Syntax
clear rmon capture index
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear RMON capture entry 1:
D2(rw)->clear rmon capture 1
index
Specifies the capture entry to be cleared.