Exido Cord Free Electrical Kettle 245-065 - Manual (Page 13)

12 1
5. Plug in and switch the power on.
o Caution! If you set the on/off switch (6) to the "I"
position before replacing the kettle on the base,
the kettle switches on automatically when
replaced on the base. For safety’s sake, check
the on/off switch position before replacing the
kettle on the base to avoid accidentally starting
the kettle.
6. Switch on the appliance by switching the on/off
button forward to "I". The on/off indicator in the
water indicator lights up, when the appliance is on
and heating the water.
The water will boil within a few minutes, depending
on the amount in the kettle. If you want to interrupt
the boiling, you can do this at any time by switching
the on/off button backward to "O". Once the water is
boiling, the kettle will automatically switch off thanks to
the integrated thermostat. The indicator light comes off
when the appliance is stopped and the on/off button
automatically switches to position “0”.
Anti boil-dry device
If you switch the kettle on without having filled it with
water, or when the water level is below the “MIN” mark,
the anti boil-dry device will automatically switch it off.
The kettle can be switched on normally, as soon as it is
filled with a sufficient amount of water.
Storage
If the kettle is to be stored for any length of time without
use, the cord can be rolled up around the inside of the
base. Ensure the appliance is clean and dry before
storing.
CLEANING THE KETTLE
When cleaning the appliance, you should pay
attention to the following points:
• Remove the plug from the wall socket and allow the
appliance to cool down before cleaning.
• Do not immerse in water or any other liquid.
• Wipe using a well-wrung cloth and hot water. A little
detergent can be added if the appliance is heavily
soiled.
• Never use scouring powder, steel scourers or
other strong cleaning agents to clean the interior
or exterior surfaces of the appliance, as they may
scratch the surfaces.
• Make sure that no water gets into the connector on
the base or the hole in the underside of the kettle.
Decalcifying the kettle
The lime content of ordinary tap water means limescale
may gradually be deposited inside. This limescale may
be loosened using acetic acid (NOT ordinary vinegar) or
descaler, available in supermarkets, etc.
1. Mix 1 dl acetic acid with  dl cold water, or follow
the instructions on the descaler packaging.
2. Pour the solution into the kettle and switch it on.
. Allow the solution to boil twice and then pour it out.
4. To remove the final residues of limescale and acetic
acid, pour cold water into the kettle again (up to the
"MAX" mark) and switch it on.
5. Pour out the water once it has boiled.
6. Repeat the process described under points 4-5
three times.
7. The filter (11) may be gently removed from the
locking devices in the spout (1).
8. Place the filter in a cup with descaler for a couple of
hours and thoroughly rinse it after decalcifying.
9. Gently replace the filter in the spout so that it is
gripped and held in place by the locking devices.
The appliance now ready for use.
INFORMATION ON DISPOSAL AND RECYCLING OF
THIS PRODUCT
Please note that this Adexi product is marked with
this symbol:
This means that this product must not be disposed of
together with ordinary household waste, as electrical
and electronic waste must be disposed of separately.
In accordance with the WEEE directive, every member
state must ensure correct collection, recovery, handling
and recycling of electrical and electronic waste. Private
households in the EU can take used equipment to
special recycling stations free of charge. In some
member states you can, in certain cases, return
the used equipment to the retailer from whom you
purchased it, if you are purchasing new equipment.
Contact your retailer, distributor or the municipal
authorities for further information on what you should
do with electrical and electronic waste.
GUARANTEE TERMS
The guarantee does not apply:
• if the above instructions are not followed
• if the appliance has been interfered with
• if the appliance has been mishandled, subjected to
rough treatment, or has suffered any other form of
damage
• If faults have arisen because of faults in your
electricity supply.
Due to the constant development of our products in
terms of function and design, we reserve the right to
make changes to the product without warning.
QUESTIONS AND ANSWERS
If you have any questions regarding use of the
appliance and cannot find the answer in this user guide,
please try our website at www.adexi.eu.
Go to the "Consumer Service" menu, click on "Question
& Answer" to see the most frequently asked questions.
You can also see contact details if you need to contact
us for technical issues, repairs, accessories and spare
parts.