Electrolux Over the Range Microwave Oven 316902903 - Manual (Page 5)

E
5
1. Remove the feature sticker from the outside of the door, if
there is one.
2. Check to see that there is a WALL TEMPLATE and TOP
CABINET TEMPLATE. Read enclosures and SAVE the Use
and Care Guide.
Check the oven for any damage, such as misaligned or bent
door, damaged door seals and sealing surfaces, broken or
loose door hinges and latches and dents inside the cavity or on
the door. If there is any damage, do not operate the oven and
contact your dealer or ELECTROLUX AUTHORIZED SERVICER.
See Installation Instructions for more details.
ORM 2.0 Bottom [TINSEB310WRRZ] [5 5 ORM 2.0 Bottom [TINSEB310WRRZ] [5 5 10/19/10 1:21:36 PM 10/19/10 1:21:36 PM
hen using the convection or combination cooking
functions, both the outside and inside of the oven
hot. Always use hot pads to remove
—Do not use regular cooking or oven
thermometers when cooking by microwave or
combination. The metal and mercury in these
to the oven. Do not use a thermometer in food you are
recommended for use in the microwave oven.
not clean with metal scouring pads. Pieces can
ff the pad and touch electrical parts involving
tric shock.
ood and cooking accessories such
wire rack and glass tray.
24.W
25.Do
26.Thermometer
as the oven shelf, round
containers of f
will become
risk of elec
burn o
ARCING
Arcing is the microwave term for sparks in the oven.
Arcing is caused by:
The metal shelf not installed correctly so it
touches the microwave wall.
Metal or foil touching the side of the oven.
Foil not molded to food (upturned edges act
like antennas).
Metal, such as twist-ties, poultry pins, or gold-
rimmed dishes, in the microwave.
Recycled paper towels containing small metal
pieces
being used in the microwave.
•
•
•
•
•
Federal Communications Commission Radio Frequency Interference Statement
(U.S.A. Only)
This equipment generates and uses ISM frequency energy and if not installed and used properly, that is in strict
found to comply with limits for ISM Equipment pursuant to part 18 of FCC Rules,
sonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
• Reorient the receiving antenna of the radio or television.
• Relocate the microwave oven with respect to the receiver.
• Move the microwave oven away from the receiver.
• Plug the microwave oven into a different outlet so that the microwave oven and the receiver are on
The manufacturer is not responsible for any radio or television interference caused by
button and correct the problem. If you see arcing, press the
unauthorized
Stop/Clear
which are designed to provide rea
has been type tested and
accordance with the manufacturer's instructions, may cause interference to radio and television reception. It
and on, the user is encouraged to try to correct the interference by one or more of the following:
does cause interference to radio or television reception, which can be determined by turning the equipment off
different branch circuits.
modification to this microwave oven. It is the responsibility of the user to correct such interference.
and possible damage thermometers could cause arcing
UNPACKING YOUR OVEN
Please remove all internal cardboard packing and wire rack accessories. Make sure you remove also the
blue tape around the door (internally) and the piece of tape that is covering the turntable base. You will
microwaving unless the thermometer is designed or
have to place the plastic ring first prior to placing the glass turntable.