Electrolux 16830 - Manual (Page 15)

• When the programme has finished, a steadily lit zero is displayed.
• Delayed start, (23 hours max.) programmed using the special button.
The countdown is updated every hour.
• Alarm code indicating a fault in the machine operation (see page 38).
Programme progress display
By selecting the wash programme, the pilot lights corre-
sponding to the various phases making up the programme
come on.
After the machine has started, only the running phase
pilot light stays on. When the programme has finished,
the END pilot light comes on.
When the programme has finished, if the OVER DOSING light comes on,
it indicates that too much detergent has been used or that the drain fil-
ter is blocked.
Cancelling a programme
To cancel a programme which is running, turn the programme selector
dial to the
O/OFF position.
Warning! After a programme which ends with water in the drum
(RINSE HOLD option), turn the selector dial first to
O and then to the
DRAIN, SPIN or DELICATE SPIN programme.
Altering a programme which is running
To alter a programme, first set the machine to PAUSE by pressing the
START/PAUSE button.
Any function can be modified before the machine starts it. After select-
ing the new option press the START/PAUSE button again to re-start the
selected programme.
To modify the selected programme turn the programme selector dial to
O/OFF and then choose a new programme.
The water is not emptied out and after pressing the START/PAUSE but-
ton again the machine restarts with the newly selected programme.
15
Description of the appliance
RINSE
RINSE +
SPIN
DRYING
END
DOOR
WASH
OVER DOSING
132984060.qxd 17/06/2005 15:58 Pagina 15