Epic Fitness EPTL09106.2 - Manual (Page 8)

8
4. Insert the Console Wire Harness (78) and the TV cable
into the Uprights (84).
Set the console assembly on the Uprights (84). Be care-
ful to avoid pinching the Console Wire Harness (78)
and the TV cable. While a second person holds the con-
sole assembly, attach it with four Console Bolts (64) and
four Star Washers (8) as shown;
start all four Console
Bolts and then firmly tighten them.
Console
Assembly
64
78
64
8
8
TV Cable
84
84
4
2. With the help of a second person, carefully raise the
Uprights (84) to a vertical position.
Have the second person hold the console assembly near
the Uprights (84) as shown. Look under the console as-
sembly and locate the Console Wire Harness (78).
Cut the plastic ties securing the Upright Wire Harness
(77) to the right Upright (84). Next, connect the Upright
Wire Harness to the Console Wire Harness (78).
See the
inset drawing. The connectors should slide together
easily and snap into place. If they do not, turn one con-
nector and then try again.
IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS TURNED ON.
84
77
78
2
Console
Assembly
77
78
3. Look under the console assembly and locate the TV
cable.
Cut the plastic ties securing the Upright TV Cable (104) to
the left Upright (84). Connect the Upright TV Cable to the
TV cable on the console assembly.
84
104
TV Cable
Console
Assembly
3