Electrolux DF 6160 - Manual (Page 16)

75
Outlet hole - Only for models DF 6260, DF 6260-ml/1
and CHDF 6260 (extractor-filter version)
• When used as an extractor unit, the hood must be fitted with a
150mm diameter hose.
Only for model DF 6260 - DF 6260-
ml/1: Should there already be a pipe
of diameter 125 mm that ducts to
the outside through the walls or roof,
it is possible to use the 150/125 mm
reduction flange provided. In this
case the hood will be slightly more
noisy.
Fix the flange on the hood outlet
hole, using 2 screws. Fig. 8a.
Filter version only
• Fix the deflector to the flange. Fig. 8b.
Outlet hole - Only for model DF 6160(extractor-filter version)
• When used as an extractor unit, the hood must be fitted with a
120mm diameter hose.
• The dimensions and position of the air outlet are given in figure 9.
• Fix the flange supplied as kit onto the exit hole (bayonet fixture).
• Using the adapter, Ш100, Ш110 and Ø125 mm exhausting pipes can
be used.
Ø 125 mm exhausting hose: insert the adapter on the flange and
remove, using a proper tool, the upper unused Ø 100 and Ø 110 mm
rings of the adapter.
Ø 110 mm exhausting pipe: same procedure, but removing
the Ø 100 mm ring only.
Ø 100 mm exhausting pipe: apply the adapter on the flange.
Fig. 8a Fig. 8b
Fig. 9
Fig. 10
A