Eureka 2940 - Manual (Page 3)

Assembly Parts
Wand and Crevice Wand. (Pull apart.)
Dusting Brush.
Hose.
Vacuum Cleaner Body.
Electrical Cord.
Handle.
Screws located in the accessory package.
1
2
3
4
6
5
How To Assemble
CAUTION: Assemble the cleaner before using.
CAUTION: Moving parts. Make sure ON/OFF switch is
in the OFF position before plugging in.
1
2
Slide the handle into the
grooves at the top of the
vacuum body as shown.
Place the two screws
(supplied) into the holes at
back of the unit and tighten
with a screwdriver.
6 Place the hose on the back
of the vacuum, wrapping
it up and over the hose
hook as shown.
Firmly push the end of
the hose into the hose
retainer in the hood of the
vacuum. 7
7
3
3 Pull the electrical cord
up to the cord retainer
and firmly push down
into retainer. This will
keep the cord out of the
way the next time you
vacuum.
Wind the cord around
the two cord hooks
on the back of the
vacuum.
Secure plug to the cord
to prevent unwinding.
4
5
8
9
Store the wands
on the side of the
vacuum in front of
the hose.
Store the dusting
brush on its
holder.
1
2
3
4
5
6