Epson B 500DN User Manual
Page 51
B-300/B-500DN
User’s Guide
Printing with Special Layout Options
51
9. Click Margins to open the Margins window.
10. Specify the edge of the paper where the binding will be placed. You can choose Left, Top, or
Right
.
11. Choose cm or inch as the Unit setting. Then specify the width of the binding margin. You can
enter any width from 0.3 cm to 3.0 cm, or from 0.12 inches to 1.18 inches.
Note:
The actual binding margin may be different from the specified settings depending on your application.
Experiment with a few sheets to examine actual results before printing the entire job.
12. Click OK to return to the Page Layout window. Then click OK to save your settings.
13. Load paper into the rear sheet feeder, then send the print job from your application.
Instructions for generating the even-numbered pages will be displayed while the
odd-numbered pages are printed.
&
See “Loading Paper” on page 22.
14. Follow the on-screen instructions to reload the paper.
Note:
❏ The paper may curl during printing due to the amount of ink used. Should this occur, slightly curl
the sheets in the opposite direction before reloading them.
❏ Align the sheet stack by tapping its edges against a hard, flat surface before reloading the stack.
❏ Follow the instructions provided when reloading the printouts. Otherwise, paper may jam or the
binding margins may be incorrect.
❏ If a paper jam occurs, refer to the following.
&