CarAlarms.com 159 - Manual (Page 3)

You get extra points for knocking
the pinball inside the spinning
wheel.
Pausing during a game
If you’d like to pause during the
game, simply press
PAUSE
. Press
again to resume your game.
Sound on/off
Press the
SOUND
button if you’d
like to switch the pinball arcade
sounds off. Press again if you’d
like to turn the sound back on.
Your Excalibur Pinball will pro-
vide you hours of fun. Please
review the safety, care and bat-
tery instructions on the following
page. And please remember to
close the flip-up scoreboard dis-
play when not in use to avoid
damaging it.
5
Getting started
To begin playing, flip up the
automatic scoreboard so that you
can see the score LCD at the top
of the unit. Then press
ON
to turn
on the game. Next press
LEFT
FLIPPER to select either Game 1
or Game 2. The game selection
will be displayed on the upper
right of the pinball LCD.
Choosing levels
Press RIGHT FLIPPER to choose
one of six levels, ranging in diffi-
culty from Level 1, the easiest, to
Level 6, the most difficult. The
level selected will be displayed
on the score LCD. After you have
made your selection, press START
to begin your game.
Putting the ball in play
You can launch a ball either by
pulling and then releasing the
PLUNGER
, or by pressing and
holding
RIGHT FLIPPER
. Once
the ball is released, use your flip-
pers to keep the ball in play.
Playing the game
You’ll be challenged by three
balls per game. To score points,
you need to knock the bricks and
hit the bubbles with each pinball.
4
Playing Vibrating Pinball
If no button is pushed for a few minutes, your
Vibrating Pinball game will
switch off to save your batteries.
Computers can sometimes “lock up” due to static
discharge or other electrical disturbances. If this
should happen, reset the game by pressing
RESET
.
SPECIAL CARE
&
HANDLING
• Avoid rough handling
such as bumping or dropping.
• Avoid moisture and
extreme temperatures. For
best results, use between the
temperatures of 39ºF and
100ºF (4º C and 38º C).
• Clean using only a slightly
damp cloth. Do not use clean-
ers with chemical agents.