100 series – Focal 100 ICW6 6.5" 2-Way In-Wall / In-Ceiling Speaker (Single) User Manual
Page 19
100 SERIES
19
We recommend using a cable with a marker in order to ensure the polarities of the speaker drivers are
respected (+/-). Choose good quality cables with a wire gauge appropriate to their length: your retailer
will be able to advise you.
• The loudspeaker fixes to the wall thanks to the rotating mounting brackets. Insert the loudspeakers into
the opening and secure the mounting brackets by rotating them clockwise using a Phillips screwdriver
or a screw-gun. If you use a screw-gun, make sure the tightening torque is set to a low value to prevent
damaging the mounting brackets (
fig. 14
). The loudspeaker will be securely fixed in place when you feel
resistance once tightened.
New constructions
• Use the specific optional mounting kit.
• Prepare the cables and make sure you leave enough cable to allow you to wire up your loudspeakers
with ease (approximately 20"/ 50cm). We recommend using a cable with a marker in order to ensure
the polarities of the speaker drivers are respected (+/-). Choose good quality cables with a wire gauge
appropriate to their length: your retailer will be able to advise you.
• The loudspeaker fixes to the wall thanks to the rotating mounting brackets. Insert the loudspeakers into
the opening and secure the mounting brackets by rotating them clockwise using a Phillips screwdriver
or a screw-gun. If you use a screw-gun, make sure the tightening torque is set to a low value to prevent
damaging the mounting brackets (
fig. 15
). The loudspeaker will be securely fixed in place when you feel
resistance once tightened.
Wiring in parallel
The impedance of each product in the 100 SERIES range allows you to wire the loudspeakers in parallel to
the same amplifier output (except for the 100 IWLCR 5 model) (
fig. 16
).
Adjusting the tweeter
The tweeter can be adjusted using the switch on the front of the loudspeaker as shown in the diagram
(
fig. 17
).
Adjusting the midrange
(100 IW 6, 100 IWLCR 5)
The midrange can be adjusted using the switch on the front of the loudspeaker as shown in the diagram
(
fig. 18
).
Orienting the tweeter
(100 ICW 6, 100 ICW 8, 100 IW 6, 100 IWLCR 5, 100 ICLCR 5)
For the models 100 ICW 6, 100 ICW 8, 100 IW 6, 100 IWLCR 5 and 100 ICLCR 5, you can direct the tweeter
towards the listening area for improved precision of the treble and of the stereo image (
fig. 19
).
ICW 6, ICW 8: angle of inclination from 0 to 20°, and 360° rotation.
IW 6, IWLCR 5, ICLCR 5: angle of inclination from 0 to 15°, and rotation on every axis.
Adjustment of the speaker mode
(100 ICLCR5)
Adjust the speaker to "L" when it’s used with the left speaker, "R" when it’s used with the right speaker, and
"C" when it’s used with the central speaker (
fig. 20
).
U s e r m a n u a l