Extron electronic MDA 3 Series - Manual (Page 7)

VersaTools ® MDA 3 Series • Installation VersaTools ® MDA 3 Series • Installation
VersaTools ® MDA 3 Series, cont’d
MA V S ER IES AV M AT RIX SW ITC HE R I/O
AU D
AU DIO SE TU P
PR ES ET
VID
IR
+dB
-dB
EN TER
2
7
6
5
2
4
1
INP UT S
OU TP UT S
8
3
1
8
6
5
4
3
7
DISTRIB
UTION AMPLIFIER
Rear
Front
Figure 4 — Typical back of the rack installations
VersaTools ® MDA 3 Series • Connections and Controls
Back of the rack mounting
The MDA can be mounted to the rear of a rack using the Extron
MBB 100 VersaTools
® back of the rack mounting kit
(part #70-367-01) (figure 3). The kit allows the product to be
vertically mounted to the front or rear rack supports and facing
either towards the front or the rear of the rack.
Figure 3 — Attaching the back of the rack kit
1 . Remove feet from the bottom of the MDA if they are
installed.
2 . Remove two screws from one side of the unit. Retain the
screws for possible later reassembly without the bracket.
3 . Attach one bracket to the side of the unit using the longer
screws included in the kit.
4 . Repeat steps 2 and 3 on the other side of the unit.
5 . Mount the unit to the rack using the two included rack
screws (figure 4). The MDA can be vertically mounted
facing in either direction.
Only VersaTools products and most IP Link products
can be mounted using the back of the rack mounting kit.
5 4