Electro-Voice CP3000S - Manual (Page 5)

4 5
UNPACKING & WARRANTY
Carefully open the packaging and take out the power amplifier. Next to the power amplifier itself, the
package also includes this owner’s manual, a mains cord and the warranty certificate. Keep the original
invoice, which states the purchase/delivery date together with the warranty certificate at a safe place.
INSTALLATION NOTES
Generally, installing or mounting CP-Series power amps should be carried out in a way that guarantees
continuously unopposed front-to-rear air circulation. Installation of appliances with opposite air circulation
within one cabinet or closed rack shelf system is not recommendable. When including appliances in a
closed cabinet or rack shelf system make sure to provide sufficient ventilation. Leave a gap of at least
60mm x 330mm (up to the cabinet’s top ventilation louvers) for air circulation between the rear of the
power amplifier and the cabinet’s/rack’s rear inner wall. Make sure to leave at least 100mm of space
above the cabinet or rack shelf system. Since temperatures inside of the cabinet or rack shelf system
can easily rise up to 40°C during operation, bearing in mind the maximally allowable environmental
temperatures for all other appliances installed in the same rack shelf system is mandatory (also refer to
“MAINS OPERATION AND RESULTING TEMPERATURE”).
Caution: For trouble-free operation exceeding the maximally allowable environmental
temperature of +40°C is not permissible.
To prevent the front panel from bending, the use of installation rails or optionally available “rear-rack-
mount” rails is obligatory when installing the appliance in a rack shelf system or cabinet.
The power amplifier has to be protected against: dripping or splashing water, direct sunlight, high
temperatures or direct influence of heat sources, high humidity, extensive dust and vibrations.
If guaranteeing the listed requirements is not possible on a long-term basis, regular servicing is
absolutely mandatory to prevent the power amplifier from possible failure, mainly being caused by
negative environmental effects.
Condensation on internal parts may occur when transporting the power amplifier from a cold into a
warmer environment. In that case operation is only permissible after the appliance has gained the new
temperature (after approximately one hour). If foreign objects or liquids have entered the power amp’s
enclosure, make sure to immediately separate the appliance from the mains power and contact an
authorized service center for inspection before continuing operation.
DESCRIPTION
FCC INFORMATION (U.S.A)
1. IMPORTANT: Do not modify this unit! Changes or modifications not expressly approved
by the manufacturer could void the user`s authority, granted by the FCC, to operate the
equipment.
2. NOTE : This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception , which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.