Electrolux 6500 K - Manual (Page 24)

What to do if ...
24
.... the cooking zones do not heat up, even though the displays
are working?
0 Check whether
– demonstration mode has been activated accidentally.
To deactivate this mode, ensure that the appliance is switched off and
that the control panel is not locked.
Then proceed as follows:
1. Switch on main button.
2. Within 10 seconds, press the following buttons simultaneously for a
maximum of one second:
– lock button
o
– cooking zone selection button, front left
– cooking zone selection switch, rear left.
When the buttons are released, a peep tone sounds as confirmation.
3. Press the
j button, a peep tone sounds as confirmation.
Your cooking surface is now ready for use again.
.... the display suddenly changes to
j or h for residual heat?
0 Check whether
–the On/Off button has been operated accidentally.
–the touch switches are partially covered by a damp cloth, liquid or
similar.
–there has been a power cut.
–the safety switch has been activated.
.... after switching off the cooking zones, neither
j nor h for
residual heat appears in the display?
0 Check whether
–the cooking zone was only used for a short period and is therefore
not hot enough.
If the cooking zone is hot, call AEG customer service.
.... a cooking zone cannot be switched off?
0 Check whether
–the touch switches are partially covered by a damp cloth or liquid.
–the lock is activated.
.... a cooking zone cannot be switched on?
0 Check whether
–the lock is activated.