Removing the battery – Epson Multimedia Photo Viewer P-6000 User Manual
Page 12
Getting Started 12
To charge the battery, connect the AC adapter as shown
below. Connect the other end to the power cord and plug it
into an electrical outlet.
Caution:
Do not connect the AC adapter when the battery is not installed;
this can damage the viewer. Turn off the viewer before
disconnecting the AC adapter.
The battery status is displayed in the top right corner of the
LCD screen when the viewer is on.
Note:
The battery may become hot when the viewer is operated
during charging. Charging will stop until the battery cools down.
Removing the Battery
If you plan to store the viewer for an extended period of
time, you should remove the battery.
1
Make sure the viewer is turned off (see page 16).
Caution:
Remove the AC adapter if it is connected to the viewer.
Never remove the battery while the viewer is turned on.
Doing so may cause files to be lost or damaged.
2
Open the battery cover.
3
Slide the battery release lever to the left. The battery
pops out.
Battery is fully charged.
Battery power is about half full.
Battery power is low.
Battery is charging.