Encore electronic ENLTV-DVB-S - Manual (Page 5)

ENLTV-DVB-S User’s Guide -
5
Chapter 2: Getting Started
2.1 Connect ENLTV-DVB-S
Notes: Satellite cable has 12V power. At the first time installation, please make sure
the PC system’s power cord has not been connected to the power jack even when
the PC’s power is in shutdown state. Turn on the PC power ONLY after the
ENLTV-DVB-S has been firmly and securely plugged into the PCI slot.
Refer to below wire connection diagram for correct connection:
Caution: Please take special care on the Remote sensor cable, don’t plug in or plug off
the sensor cable while the PC system is in Power on state. Otherwise, it may cause
ENLTV-DVB-S hardware failure.
Satellite Dish cable input
Remote sensor cable input
Audio out
4 to 1 Audio / Video cable in