Epson PictureMate User Manual

Start here, Unpack, Install the photo cartridge

Advertising
background image

®

Start Here

Set up your PictureMate and
print –no computer required!

Note:

To print from your computer, see

Using PictureMate With a

Computer and your CD after completing these steps.

1

Unpack

PictureMate comes with all these items in the box.

Remove all the tape and packing material from PictureMate.

Caution:

To avoid damaging your PictureMate,

keep it out of the sun and don’t leave it in your
car or other location where it can get too hot.

2

Install the Photo
Cartridge

1

Flip the handle up.

2

Open the cartridge door
on the back of PictureMate.
You see the release lever.

3

Move the lever to the Release position by sliding it
in the direction shown.

4

Shake the photo cartridge
a few times in its package,
then unwrap the cartridge.

5

Slide the cartridge straight into the slot, label side up,
until it is fully inserted. Push in both sides evenly to
make sure it is not crooked.

Caution:

Make sure both sides of the cartridge are even,

or ink may leak. If either side is sticking out, remove the
cartridge and reinstall it.

6

Move the lever right to the Lock position. If it does
not lock in place, the cartridge is not installed
correctly. Release it and try again.

7

Close the cartridge door. Make sure it snaps shut.

If the door does not close completely, the cartridge is
not installed correctly. Remove it and try again.

8

Flip the handle to the
back of PictureMate
and all the way down.

3

Plug In and Turn
On PictureMate

1

Connect the power cable
to the power adapter.

2

Plug the small cable into
the back of PictureMate.

3

Plug the other end of
the power cable into a
standard power outlet.

4

Press the On button to turn on PictureMate.

PictureMate gets the ink ready for printing.
You see this message:

After a few minutes, when PictureMate is ready,
you see this message:

5

Press the OK button.

4

Load Paper

Your PictureMate comes with photo paper made especially
for it.

Caution:

Don’t load or print on plain paper; this may damage

PictureMate.

1

Flip open the
paper support.

2

Pull up the paper
support all the way.

3

Open the output tray.

Note:

Make sure the paper support is fully extended.

PictureMate

Power cable

PictureMate Photo Cartridge

Paper

Using PictureMate

Without a Computer

booklet

Printer

Software

CD

+

Turn over

Using PictureMate

With a Computer

booklet

Power adapter

4051812-00 XXX

To release lever

Handle

Lever

Make sure the handle

is all the way down

Wrong

Right

Advertising